fec: refactor init function
fec_enet_init() does the hardware initialisation and then calls fec_restart() which does the same initialisation again, so we can safely remove the initialisation from fec_enet_init(). Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de> Signed-off-by: David S. Miller <davem@davemloft.net>
This commit is contained in:
parent
4e8318368a
commit
4f1ceb4b46
|
@ -1615,10 +1615,6 @@ int __init fec_enet_init(struct net_device *dev, int index)
|
|||
fep->hwp = (void __iomem *)dev->base_addr;
|
||||
fep->netdev = dev;
|
||||
|
||||
/* Whack a reset. We should wait for this. */
|
||||
writel(1, fep->hwp + FEC_ECNTRL);
|
||||
udelay(10);
|
||||
|
||||
/* Set the Ethernet address */
|
||||
#ifdef CONFIG_M5272
|
||||
fec_get_mac(dev);
|
||||
|
@ -1640,11 +1636,6 @@ int __init fec_enet_init(struct net_device *dev, int index)
|
|||
fep->rx_bd_base = cbd_base;
|
||||
fep->tx_bd_base = cbd_base + RX_RING_SIZE;
|
||||
|
||||
fep->dirty_tx = fep->cur_tx = fep->tx_bd_base;
|
||||
fep->cur_rx = fep->rx_bd_base;
|
||||
|
||||
fep->skb_cur = fep->skb_dirty = 0;
|
||||
|
||||
/* Initialize the receive buffer descriptors. */
|
||||
bdp = fep->rx_bd_base;
|
||||
for (i=0; i<FEC_ENET_RX_PAGES; i++) {
|
||||
|
@ -1688,25 +1679,9 @@ int __init fec_enet_init(struct net_device *dev, int index)
|
|||
bdp--;
|
||||
bdp->cbd_sc |= BD_SC_WRAP;
|
||||
|
||||
/* Set receive and transmit descriptor base */
|
||||
writel(fep->bd_dma, fep->hwp + FEC_R_DES_START);
|
||||
writel((unsigned long)fep->bd_dma + sizeof(struct bufdesc) * RX_RING_SIZE,
|
||||
fep->hwp + FEC_X_DES_START);
|
||||
|
||||
#ifdef HAVE_mii_link_interrupt
|
||||
fec_request_mii_intr(dev);
|
||||
#endif
|
||||
|
||||
writel(0, fep->hwp + FEC_GRP_HASH_TABLE_HIGH);
|
||||
writel(0, fep->hwp + FEC_GRP_HASH_TABLE_LOW);
|
||||
writel(PKT_MAXBLR_SIZE, fep->hwp + FEC_R_BUFF_SIZE);
|
||||
writel(2, fep->hwp + FEC_ECNTRL);
|
||||
writel(0, fep->hwp + FEC_R_DES_ACTIVE);
|
||||
#ifndef CONFIG_M5272
|
||||
writel(0, fep->hwp + FEC_HASH_TABLE_HIGH);
|
||||
writel(0, fep->hwp + FEC_HASH_TABLE_LOW);
|
||||
#endif
|
||||
|
||||
/* The FEC Ethernet specific entries in the device structure */
|
||||
dev->open = fec_enet_open;
|
||||
dev->hard_start_xmit = fec_enet_start_xmit;
|
||||
|
@ -1719,21 +1694,11 @@ int __init fec_enet_init(struct net_device *dev, int index)
|
|||
mii_cmds[i].mii_next = &mii_cmds[i+1];
|
||||
mii_free = mii_cmds;
|
||||
|
||||
/* setup MII interface */
|
||||
writel(OPT_FRAME_SIZE | 0x04, fep->hwp + FEC_R_CNTRL);
|
||||
writel(0, fep->hwp + FEC_X_CNTRL);
|
||||
|
||||
/* Set MII speed to 2.5 MHz */
|
||||
fep->phy_speed = ((((clk_get_rate(fep->clk) / 2 + 4999999)
|
||||
/ 2500000) / 2) & 0x3F) << 1;
|
||||
writel(fep->phy_speed, fep->hwp + FEC_MII_SPEED);
|
||||
fec_restart(dev, 0);
|
||||
|
||||
/* Clear and enable interrupts */
|
||||
writel(0xffc00000, fep->hwp + FEC_IEVENT);
|
||||
writel(FEC_ENET_TXF | FEC_ENET_RXF | FEC_ENET_MII,
|
||||
fep->hwp + FEC_IMASK);
|
||||
|
||||
/* Queue up command to detect the PHY and initialize the
|
||||
* remainder of the interface.
|
||||
*/
|
||||
|
@ -1768,6 +1733,10 @@ fec_restart(struct net_device *dev, int duplex)
|
|||
/* Reset all multicast. */
|
||||
writel(0, fep->hwp + FEC_GRP_HASH_TABLE_HIGH);
|
||||
writel(0, fep->hwp + FEC_GRP_HASH_TABLE_LOW);
|
||||
#ifndef CONFIG_M5272
|
||||
writel(0, fep->hwp + FEC_HASH_TABLE_HIGH);
|
||||
writel(0, fep->hwp + FEC_HASH_TABLE_LOW);
|
||||
#endif
|
||||
|
||||
/* Set maximum receive buffer size. */
|
||||
writel(PKT_MAXBLR_SIZE, fep->hwp + FEC_R_BUFF_SIZE);
|
||||
|
|
Loading…
Reference in New Issue