clk: Add Si5341/Si5340 driver
Adds a driver for the Si5341 and Si5340 chips. The driver does not fully support all features of these chips, but allows the chip to be used without any support from the "clockbuilder pro" software. If the chip is preprogrammed, that is, you bought one with some defaults burned in, or you programmed the NVM in some way, the driver will just take over the current settings and only change them on demand. Otherwise the input must be a fixed XTAL in its most basic configuration (no predividers, no feedback, etc.). The driver supports dynamic changes of multisynth, output dividers and enabling or powering down outputs and multisynths. Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl> [sboyd@kernel.org: Mark some things static, use BIT_ULL for big bits and ULL for big constants] Signed-off-by: Stephen Boyd <sboyd@kernel.org>
This commit is contained in:
parent
d743ea67cb
commit
3044a860fd
|
@ -91,6 +91,17 @@ config COMMON_CLK_SCPI
|
|||
This driver uses SCPI Message Protocol to interact with the
|
||||
firmware providing all the clock controls.
|
||||
|
||||
config COMMON_CLK_SI5341
|
||||
tristate "Clock driver for SiLabs 5341 and 5340 A/B/C/D devices"
|
||||
depends on I2C
|
||||
select REGMAP_I2C
|
||||
help
|
||||
This driver supports Silicon Labs Si5341 and Si5340 programmable clock
|
||||
generators. Not all features of these chips are currently supported
|
||||
by the driver, in particular it only supports XTAL input. The chip can
|
||||
be pre-programmed to support other configurations and features not yet
|
||||
implemented in the driver.
|
||||
|
||||
config COMMON_CLK_SI5351
|
||||
tristate "Clock driver for SiLabs 5351A/B/C"
|
||||
depends on I2C
|
||||
|
|
|
@ -49,6 +49,7 @@ obj-$(CONFIG_COMMON_CLK_HI655X) += clk-hi655x.o
|
|||
obj-$(CONFIG_COMMON_CLK_S2MPS11) += clk-s2mps11.o
|
||||
obj-$(CONFIG_COMMON_CLK_SCMI) += clk-scmi.o
|
||||
obj-$(CONFIG_COMMON_CLK_SCPI) += clk-scpi.o
|
||||
obj-$(CONFIG_COMMON_CLK_SI5341) += clk-si5341.o
|
||||
obj-$(CONFIG_COMMON_CLK_SI5351) += clk-si5351.o
|
||||
obj-$(CONFIG_COMMON_CLK_SI514) += clk-si514.o
|
||||
obj-$(CONFIG_COMMON_CLK_SI544) += clk-si544.o
|
||||
|
|
File diff suppressed because it is too large
Load Diff
Loading…
Reference in New Issue