drm/i915: fix gpio register detection logic for BIOS without VBT
if no VBT is present, crt_ddc_bus will be left at 0, and cause us to use that for the GPIO register offset. That's never a valid register offset, so let the "undefined" value be 0 instead of -1. Signed-off-by: Shaohua Li <shaohua.li@intel.com> Signed-off-by: Zhao Yakui <yakui.zhao@intel.com> Signed-off-by: Eric Anholt <eric@anholt.net> [anholt: clarified the commit message a bit]
This commit is contained in:
parent
d271817bae
commit
29874f44fb
|
@ -266,7 +266,7 @@ typedef struct drm_i915_private {
|
|||
|
||||
struct notifier_block lid_notifier;
|
||||
|
||||
int crt_ddc_bus; /* -1 = unknown, else GPIO to use for CRT DDC */
|
||||
int crt_ddc_bus; /* 0 = unknown, else GPIO to use for CRT DDC */
|
||||
struct drm_i915_fence_reg fence_regs[16]; /* assume 965 */
|
||||
int fence_reg_start; /* 4 if userland hasn't ioctl'd us yet */
|
||||
int num_fence_regs; /* 8 on pre-965, 16 otherwise */
|
||||
|
|
|
@ -283,10 +283,6 @@ parse_general_definitions(struct drm_i915_private *dev_priv,
|
|||
GPIOF,
|
||||
};
|
||||
|
||||
/* Set sensible defaults in case we can't find the general block
|
||||
or it is the wrong chipset */
|
||||
dev_priv->crt_ddc_bus = -1;
|
||||
|
||||
general = find_section(bdb, BDB_GENERAL_DEFINITIONS);
|
||||
if (general) {
|
||||
u16 block_size = get_blocksize(general);
|
||||
|
|
|
@ -526,7 +526,7 @@ void intel_crt_init(struct drm_device *dev)
|
|||
else {
|
||||
i2c_reg = GPIOA;
|
||||
/* Use VBT information for CRT DDC if available */
|
||||
if (dev_priv->crt_ddc_bus != -1)
|
||||
if (dev_priv->crt_ddc_bus != 0)
|
||||
i2c_reg = dev_priv->crt_ddc_bus;
|
||||
}
|
||||
intel_output->ddc_bus = intel_i2c_create(dev, i2c_reg, "CRTDDC_A");
|
||||
|
|
Loading…
Reference in New Issue