Merge branch 'spi-5.3' into spi-linus

Documentation/devicetree/bindings/spi/spi-controller.yaml

@@ -31,7 +31,7 @@ properties:
       If that property is used, the number of chip selects will be
       increased automatically with max(cs-gpios, hardware chip selects).
 
-      So if, for example, the controller has 2 CS lines, and the
+      So if, for example, the controller has 4 CS lines, and the
       cs-gpios looks like this
         cs-gpios = <&gpio1 0 0>, <0>, <&gpio1 1 0>, <&gpio1 2 0>;
 

drivers/spi/spi-bcm-qspi.c

@@ -343,7 +343,7 @@ static int bcm_qspi_bspi_set_flex_mode(struct bcm_qspi *qspi,
 {
 	int bpc = 0, bpp = 0;
 	u8 command = op->cmd.opcode;
-	int width  = op->cmd.buswidth ? op->cmd.buswidth : SPI_NBITS_SINGLE;
+	int width = op->data.buswidth ? op->data.buswidth : SPI_NBITS_SINGLE;
 	int addrlen = op->addr.nbytes;
 	int flex_mode = 1;
 
@@ -981,7 +981,7 @@ static int bcm_qspi_exec_mem_op(struct spi_mem *mem,
 	if (mspi_read)
 		return bcm_qspi_mspi_exec_mem_op(spi, op);
 
-	ret = bcm_qspi_bspi_set_mode(qspi, op, -1);
+	ret = bcm_qspi_bspi_set_mode(qspi, op, 0);
 
 	if (!ret)
 		ret = bcm_qspi_bspi_exec_mem_op(spi, op);

drivers/spi/spi-bcm2835.c

@@ -319,6 +319,13 @@ static void bcm2835_spi_reset_hw(struct spi_controller *ctlr)
 		BCM2835_SPI_CS_INTD |
 		BCM2835_SPI_CS_DMAEN |
 		BCM2835_SPI_CS_TA);
+	/*
+	 * Transmission sometimes breaks unless the DONE bit is written at the
+	 * end of every transfer.  The spec says it's a RO bit.  Either the
+	 * spec is wrong and the bit is actually of type RW1C, or it's a
+	 * hardware erratum.
+	 */
+	cs |= BCM2835_SPI_CS_DONE;
 	/* and reset RX/TX FIFOS */
 	cs |= BCM2835_SPI_CS_CLEAR_RX | BCM2835_SPI_CS_CLEAR_TX;
 
@@ -477,7 +484,9 @@ static void bcm2835_spi_transfer_prologue(struct spi_controller *ctlr,
 		bcm2835_wr_fifo_count(bs, bs->rx_prologue);
 		bcm2835_wait_tx_fifo_empty(bs);
 		bcm2835_rd_fifo_count(bs, bs->rx_prologue);
-		bcm2835_spi_reset_hw(ctlr);
+		bcm2835_wr(bs, BCM2835_SPI_CS, cs | BCM2835_SPI_CS_CLEAR_RX
+						  | BCM2835_SPI_CS_CLEAR_TX
+						  | BCM2835_SPI_CS_DONE);
 
 		dma_sync_single_for_device(ctlr->dma_rx->device->dev,
 					   sg_dma_address(&tfr->rx_sg.sgl[0]),
@@ -498,7 +507,8 @@ static void bcm2835_spi_transfer_prologue(struct spi_controller *ctlr,
 						  | BCM2835_SPI_CS_DMAEN);
 		bcm2835_wr_fifo_count(bs, tx_remaining);
 		bcm2835_wait_tx_fifo_empty(bs);
-		bcm2835_wr(bs, BCM2835_SPI_CS, cs | BCM2835_SPI_CS_CLEAR_TX);
+		bcm2835_wr(bs, BCM2835_SPI_CS, cs | BCM2835_SPI_CS_CLEAR_TX
+						  | BCM2835_SPI_CS_DONE);
 	}
 
 	if (likely(!bs->tx_spillover)) {

drivers/spi/spi-dw-pci.c

@@ -19,6 +19,7 @@ struct spi_pci_desc {
 	int	(*setup)(struct dw_spi *);
 	u16	num_cs;
 	u16	bus_num;
+	u32	max_freq;
 };
 
 static struct spi_pci_desc spi_pci_mid_desc_1 = {
@@ -33,6 +34,12 @@ static struct spi_pci_desc spi_pci_mid_desc_2 = {
 	.bus_num = 1,
 };
 
+static struct spi_pci_desc spi_pci_ehl_desc = {
+	.num_cs = 1,
+	.bus_num = -1,
+	.max_freq = 100000000,
+};
+
 static int spi_pci_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
 {
 	struct dw_spi *dws;
@@ -65,6 +72,7 @@ static int spi_pci_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
 	if (desc) {
 		dws->num_cs = desc->num_cs;
 		dws->bus_num = desc->bus_num;
+		dws->max_freq = desc->max_freq;
 
 		if (desc->setup) {
 			ret = desc->setup(dws);
@@ -125,8 +133,14 @@ static const struct pci_device_id pci_ids[] = {
 	{ PCI_VDEVICE(INTEL, 0x0800), (kernel_ulong_t)&spi_pci_mid_desc_1},
 	/* Intel MID platform SPI controller 2 */
 	{ PCI_VDEVICE(INTEL, 0x0812), (kernel_ulong_t)&spi_pci_mid_desc_2},
+	/* Intel Elkhart Lake PSE SPI controllers */
+	{ PCI_VDEVICE(INTEL, 0x4b84), (kernel_ulong_t)&spi_pci_ehl_desc},
+	{ PCI_VDEVICE(INTEL, 0x4b85), (kernel_ulong_t)&spi_pci_ehl_desc},
+	{ PCI_VDEVICE(INTEL, 0x4b86), (kernel_ulong_t)&spi_pci_ehl_desc},
+	{ PCI_VDEVICE(INTEL, 0x4b87), (kernel_ulong_t)&spi_pci_ehl_desc},
 	{},
 };
+MODULE_DEVICE_TABLE(pci, pci_ids);
 
 static struct pci_driver dw_spi_driver = {
 	.name =		DRIVER_NAME,

drivers/spi/spi-fsl-dspi.c

@@ -886,9 +886,11 @@ static irqreturn_t dspi_interrupt(int irq, void *dev_id)
 					trans_mode);
 			}
 		}
-	}
 
 		return IRQ_HANDLED;
+	}
+
+	return IRQ_NONE;
 }
 
 static const struct of_device_id fsl_dspi_dt_ids[] = {

drivers/spi/spi-uniphier.c

@@ -214,6 +214,7 @@ static void uniphier_spi_setup_transfer(struct spi_device *spi,
 	if (!priv->is_save_param || priv->mode != spi->mode) {
 		uniphier_spi_set_mode(spi);
 		priv->mode = spi->mode;
+		priv->is_save_param = false;
 	}
 
 	if (!priv->is_save_param || priv->bits_per_word != t->bits_per_word) {

drivers/spi/spi-zynq-qspi.c

@@ -695,7 +695,7 @@ static int zynq_qspi_probe(struct platform_device *pdev)
 	ctlr->setup = zynq_qspi_setup_op;
 	ctlr->max_speed_hz = clk_get_rate(xqspi->refclk) / 2;
 	ctlr->dev.of_node = np;
-	ret = spi_register_controller(ctlr);
+	ret = devm_spi_register_controller(&pdev->dev, ctlr);
 	if (ret) {
 		dev_err(&pdev->dev, "spi_register_master failed\n");
 		goto clk_dis_all;