ARM: OMAP: No need to include board-h3.h from hardware.h

Also move board-h3.h to mach-omap1.

Signed-off-by: Tony Lindgren <tony@atomide.com>

arch/arm/mach-omap1/board-h3-mmc.c

@@ -19,6 +19,8 @@
 #include <mach/mmc.h>
 #include <mach/gpio.h>
 
+#include "board-h3.h"
+
 #if defined(CONFIG_MMC_OMAP) || defined(CONFIG_MMC_OMAP_MODULE)
 
 static int mmc_set_power(struct device *dev, int slot, int power_on,

arch/arm/mach-omap1/board-h3.c

@@ -50,6 +50,11 @@
 #include <mach/dma.h>
 #include <mach/common.h>
 
+#include "board-h3.h"
+
+/* In OMAP1710 H3 the Ethernet is directly connected to CS1 */
+#define OMAP1710_ETHR_START		0x04000300
+
 #define H3_TS_GPIO	48
 
 static int h3_keymap[] = {

arch/arm/mach-omap1/board-h3.h

@@ -1,5 +1,5 @@
 /*
- * arch/arm/plat-omap/include/mach/board-h3.h
+ * arch/arm/mach-omap1/board-h3.h
  *
  * Copyright (C) 2001 RidgeRun, Inc.
  * Copyright (C) 2004 Texas Instruments, Inc.
@@ -27,9 +27,6 @@
 #ifndef __ASM_ARCH_OMAP_H3_H
 #define __ASM_ARCH_OMAP_H3_H
 
-/* In OMAP1710 H3 the Ethernet is directly connected to CS1 */
-#define OMAP1710_ETHR_START		0x04000300
-
 #define H3_TPS_GPIO_BASE		(OMAP_MAX_GPIO_LINES + 16 /* MPUIO */)
 #	define H3_TPS_GPIO_MMC_PWR_EN	(H3_TPS_GPIO_BASE + 4)
 

arch/arm/plat-omap/include/mach/hardware.h

@@ -298,10 +298,6 @@
 #include "board-innovator.h"
 #endif
 
-#ifdef CONFIG_MACH_OMAP_H3
-#include "board-h3.h"
-#endif
-
 #ifdef CONFIG_MACH_OMAP_H4
 #include "board-h4.h"
 #endif