DM9000: Remove redudant use of "& 0xff"
The writing of the data should implicitly truncate the data to 8bits, so do not bother with the ands in the code. Signed-off-by: Ben Dooks <ben-linux@fluff.org> Signed-off-by: Jeff Garzik <jeff@garzik.org>
This commit is contained in:
parent
d39cb7866e
commit
073d3f46e5
|
@ -814,8 +814,8 @@ dm9000_start_xmit(struct sk_buff *skb, struct net_device *dev)
|
|||
/* TX control: First packet immediately send, second packet queue */
|
||||
if (db->tx_pkt_cnt == 1) {
|
||||
/* Set TX length to DM9000 */
|
||||
iow(db, DM9000_TXPLL, skb->len & 0xff);
|
||||
iow(db, DM9000_TXPLH, (skb->len >> 8) & 0xff);
|
||||
iow(db, DM9000_TXPLL, skb->len);
|
||||
iow(db, DM9000_TXPLH, skb->len >> 8);
|
||||
|
||||
/* Issue TX polling command */
|
||||
iow(db, DM9000_TCR, TCR_TXREQ); /* Cleared after TX complete */
|
||||
|
@ -890,8 +890,8 @@ dm9000_tx_done(struct net_device *dev, board_info_t * db)
|
|||
|
||||
/* Queue packet check & send */
|
||||
if (db->tx_pkt_cnt > 0) {
|
||||
iow(db, DM9000_TXPLL, db->queue_pkt_len & 0xff);
|
||||
iow(db, DM9000_TXPLH, (db->queue_pkt_len >> 8) & 0xff);
|
||||
iow(db, DM9000_TXPLL, db->queue_pkt_len);
|
||||
iow(db, DM9000_TXPLH, db->queue_pkt_len >> 8);
|
||||
iow(db, DM9000_TCR, TCR_TXREQ);
|
||||
dev->trans_start = jiffies;
|
||||
}
|
||||
|
@ -1275,8 +1275,8 @@ dm9000_phy_write(struct net_device *dev, int phyaddr_unused, int reg, int value)
|
|||
iow(db, DM9000_EPAR, DM9000_PHY | reg);
|
||||
|
||||
/* Fill the written data into REG_0D & REG_0E */
|
||||
iow(db, DM9000_EPDRL, (value & 0xff));
|
||||
iow(db, DM9000_EPDRH, ((value >> 8) & 0xff));
|
||||
iow(db, DM9000_EPDRL, value);
|
||||
iow(db, DM9000_EPDRH, value >> 8);
|
||||
|
||||
iow(db, DM9000_EPCR, 0xa); /* Issue phyxcer write command */
|
||||
|
||||
|
|
Loading…
Reference in New Issue