OpenCloudOS-Kernel/drivers/mmc/core/mmc_ops.h

61 lines
2.2 KiB
C
Raw Normal View History

/* SPDX-License-Identifier: GPL-2.0-or-later */
/*
* linux/drivers/mmc/core/mmc_ops.h
*
* Copyright 2006-2007 Pierre Ossman
*/
#ifndef _MMC_MMC_OPS_H
#define _MMC_MMC_OPS_H
#include <linux/types.h>
enum mmc_busy_cmd {
MMC_BUSY_CMD6,
MMC_BUSY_ERASE,
MMC_BUSY_HPI,
MMC_BUSY_EXTR_SINGLE,
};
struct mmc_host;
struct mmc_card;
struct mmc_command;
int mmc_select_card(struct mmc_card *card);
int mmc_deselect_cards(struct mmc_host *host);
int mmc_set_dsr(struct mmc_host *host);
int mmc_go_idle(struct mmc_host *host);
int mmc_send_op_cond(struct mmc_host *host, u32 ocr, u32 *rocr);
int mmc_set_relative_addr(struct mmc_card *card);
int mmc_send_adtc_data(struct mmc_card *card, struct mmc_host *host, u32 opcode,
u32 args, void *buf, unsigned len);
int mmc_send_csd(struct mmc_card *card, u32 *csd);
int __mmc_send_status(struct mmc_card *card, u32 *status, unsigned int retries);
int mmc_send_status(struct mmc_card *card, u32 *status);
MMC core learns about SPI Teach the MMC/SD/SDIO core about using SPI mode. - Use mmc_host_is_spi() so enumeration works through SPI signaling and protocols, not just the native versions. - Provide the SPI response type flags with each request issued, including requests from the new lock/unlock code. - Understand that cmd->resp[0] and mmc_get_status() results for SPI return different values than for "native" MMC/SD protocol; this affects resetting, checking card lock status, and some others. - Understand that some commands act a bit differently ... notably: * OP_COND command doesn't return the OCR * APP_CMD status doesn't have an R1_APP_CMD analogue Those changes required some new and updated primitives: - Provide utilities to access two SPI-only requests, and one request that wasn't previously needed: * mmc_spi_read_ocr() ... SPI only * mmc_spi_set_crc() ... SPI only (override by module parm) * mmc_send_cid() ... for use without broadcast mode - Updated internal routines: * Previous mmc_send_csd() modified into mmc_send_cxd_native(); it uses native "R2" responses, which include 16 bytes of data. * Previous mmc_send_ext_csd() becomes new mmc_send_cxd_data() helper for command-and-data access * Bugfix to that mmc_send_cxd_data() code: dma-to-stack is unsafe/nonportable, so kmalloc a bounce buffer instead. - Modified mmc_send_ext_csd() now uses mmc_send_cxd_data() helper - Modified mmc_send_csd(), and new mmc_spi_send_cid(), routines use those helper routines based on whether they're native or SPI The newest categories of cards supported by the MMC stack aren't expected to work yet with SPI: MMC or SD cards with over 4GB data, and SDIO. All those cards support SPI mode, so eventually they should work too. Signed-off-by: David Brownell <dbrownell@users.sourceforge.net> Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
2007-08-09 00:11:32 +08:00
int mmc_send_cid(struct mmc_host *host, u32 *cid);
int mmc_spi_read_ocr(struct mmc_host *host, int highcap, u32 *ocrp);
int mmc_spi_set_crc(struct mmc_host *host, int use_crc);
int mmc_bus_test(struct mmc_card *card, u8 bus_width);
int mmc_can_ext_csd(struct mmc_card *card);
int mmc_get_ext_csd(struct mmc_card *card, u8 **new_ext_csd);
int mmc_switch_status(struct mmc_card *card, bool crc_err_fatal);
bool mmc_prepare_busy_cmd(struct mmc_host *host, struct mmc_command *cmd,
unsigned int timeout_ms);
int __mmc_poll_for_busy(struct mmc_card *card, unsigned int timeout_ms,
int (*busy_cb)(void *cb_data, bool *busy),
void *cb_data);
int mmc_poll_for_busy(struct mmc_card *card, unsigned int timeout_ms,
bool retry_crc_err, enum mmc_busy_cmd busy_cmd);
int __mmc_switch(struct mmc_card *card, u8 set, u8 index, u8 value,
unsigned int timeout_ms, unsigned char timing,
bool send_status, bool retry_crc_err, unsigned int retries);
int mmc_switch(struct mmc_card *card, u8 set, u8 index, u8 value,
unsigned int timeout_ms);
void mmc_run_bkops(struct mmc_card *card);
int mmc_cmdq_enable(struct mmc_card *card);
int mmc_cmdq_disable(struct mmc_card *card);
int mmc_sanitize(struct mmc_card *card, unsigned int timeout_ms);
#endif