2013-03-08 20:52:09 +08:00
|
|
|
Texas Instruments TAS5086 6-channel PWM Processor
|
|
|
|
|
|
|
|
|
|
Required properties:
|
|
|
|
|
|
|
|
|
|
- compatible: Should contain "ti,tas5086".
|
|
|
|
|
- reg: The i2c address. Should contain <0x1b>.
|
|
|
|
|
|
|
|
|
|
Optional properties:
|
|
|
|
|
|
|
|
|
|
- reset-gpio: A GPIO spec to define which pin is connected to the
|
|
|
|
|
chip's !RESET pin. If specified, the driver will
|
|
|
|
|
assert a hardware reset at probe time.
|
|
|
|
|
|
|
|
|
|
- ti,charge-period: This property should contain the time in microseconds
|
|
|
|
|
that closely matches the external single-ended
|
|
|
|
|
split-capacitor charge period. The hardware chip
|
|
|
|
|
waits for this period of time before starting the
|
|
|
|
|
PWM signals. This helps reduce pops and clicks.
|
|
|
|
|
|
|
|
|
|
When not specified, the hardware default of 1300ms
|
|
|
|
|
is retained.
|
|
|
|
|
|
2013-06-24 22:25:32 +08:00
|
|
|
- ti,mid-z-channel-X: Boolean properties, X being a number from 1 to 6.
|
|
|
|
|
If given, channel X will start with the Mid-Z start
|
|
|
|
|
sequence, otherwise the default Low-Z scheme is used.
|
|
|
|
|
|
|
|
|
|
The correct configuration depends on how the power
|
|
|
|
|
stages connected to the PWM output pins work. Not all
|
|
|
|
|
power stages are compatible to Mid-Z - please refer
|
|
|
|
|
to the datasheets for more details.
|
|
|
|
|
|
|
|
|
|
Most systems should not set any of these properties.
|
|
|
|
|
|
2014-07-03 22:56:43 +08:00
|
|
|
- avdd-supply: Power supply for AVDD, providing 3.3V
|
|
|
|
|
- dvdd-supply: Power supply for DVDD, providing 3.3V
|
|
|
|
|
|
2013-03-08 20:52:09 +08:00
|
|
|
Examples:
|
|
|
|
|
|
|
|
|
|
i2c_bus {
|
|
|
|
|
tas5086@1b {
|
|
|
|
|
compatible = "ti,tas5086";
|
|
|
|
|
reg = <0x1b>;
|
|
|
|
|
reset-gpio = <&gpio 23 0>;
|
|
|
|
|
ti,charge-period = <156000>;
|
2014-07-03 22:56:43 +08:00
|
|
|
avdd-supply = <&vdd_3v3_reg>;
|
|
|
|
|
dvdd-supply = <&vdd_3v3_reg>;
|
2013-03-08 20:52:09 +08:00
|
|
|
};
|
|
|
|
|
};
|
