OpenCloudOS-Kernel/drivers/clk/rockchip/Makefile

#
# Rockchip Clock specific Makefile
#

obj-y	+= clk-rockchip.o
obj-y	+= clk.o
obj-y	+= clk-pll.o
obj-y	+= clk-cpu.o
obj-y	+= clk-inverter.o
obj-y	+= clk-mmc-phase.o
obj-y	+= clk-muxgrf.o
obj-y	+= clk-ddr.o
obj-$(CONFIG_RESET_CONTROLLER)	+= softrst.o

obj-y	+= clk-rv1108.o
obj-y	+= clk-rk3036.o
obj-y	+= clk-rk3188.o
obj-y	+= clk-rk3228.o
obj-y	+= clk-rk3288.o
obj-y	+= clk-rk3328.o
obj-y	+= clk-rk3368.o
obj-y	+= clk-rk3399.o
clk: add support for Rockchip gate clocks This adds basic support for gate-clocks on Rockchip SoCs. There are 16 gates in each register and use the HIWORD_MASK mechanism for changing gate settings. The gate registers form a continuos block which makes the dt node structure a matter of taste, as either all 160 gates can be put into one gate clock spanning all registers or they can be divided into the 10 individual gates containing 16 clocks each. The code supports both approaches. Signed-off-by: Heiko Stuebner <heiko@sntech.de> Signed-off-by: Mike Turquette <mturquette@linaro.org> 2013-06-13 22:59:40 +08:00			`#`
			`# Rockchip Clock specific Makefile`
			`#`

			`obj-y += clk-rockchip.o`
clk: rockchip: add basic infrastructure for clock branches This adds infrastructure for registering clock branches. On Rockchip SoCs most clock branches are a combination of mux,divider and gate components, thus a composite clock is used when appropriate. Clock branches are supposed to be declared in an array using the COMPOSITE* or MUX, etc makros defined in the header and then registered using rockchip_clk_register_branches. Signed-off-by: Heiko Stuebner <heiko@sntech.de> Acked-By: Max Schwarz <max.schwarz@online.de> Tested-By: Max Schwarz <max.schwarz@online.de> Signed-off-by: Mike Turquette <mturquette@linaro.org> 2014-07-03 07:58:39 +08:00			`obj-y += clk.o`
clk: rockchip: add clock type for pll clocks and pll used on rk3066 All known Rockchip SoCs down to the RK28xx (ARM9) use a similar pattern to handle their plls: \|--\ xin32k ----------------\|mux\ xin24m -----\| pll \|----\|pll\|--- pll output \---------------\|src/ \|--/ The pll output is sourced from 1 of 3 sources, the actual pll being one of them. To change the pll frequency it is imperative to remux it to another source beforehand. This is done by adding a clock-listener to the pll that handles the remuxing before and after the rate change. The output mux is implemented as a separate clock to make use of already existing common-clock features for disabling the pll if one of the other two sources is used. Signed-off-by: Heiko Stuebner <heiko@sntech.de> Acked-By: Max Schwarz <max.schwarz@online.de> Tested-By: Max Schwarz <max.schwarz@online.de> Signed-off-by: Mike Turquette <mturquette@linaro.org> 2014-07-03 07:59:10 +08:00			`obj-y += clk-pll.o`
clk: rockchip: add new clock-type for the cpuclk When changing the armclk on Rockchip SoCs it is supposed to be reparented to an alternate parent before changing the underlying pll and back after the change. Additionally there exist clocks that are very tightly bound to the armclk whose divider values are set according to the armclk rate. Add a special clock-type to handle all that. The rate table and divider values will be supplied from the soc-specific clock controllers. Signed-off-by: Heiko Stuebner <heiko@sntech.de> Reviewed-by: Doug Anderson <dianders@chromium.org> On a rk3288-board: Tested-by: Doug Anderson <dianders@chromium.org> 2014-09-05 04:10:43 +08:00			`obj-y += clk-cpu.o`
clk: rockchip: add support for phase inverters Most Rockchip socs have optional phase inverters connected to some clocks that move the clock-phase by 180 degrees. Signed-off-by: Heiko Stuebner <heiko@sntech.de> [sboyd@codeaurora.org: Dropped lazy part of commit text] Signed-off-by: Stephen Boyd <sboyd@codeaurora.org> 2015-07-05 17:00:14 +08:00			`obj-y += clk-inverter.o`
clk: rockchip: Add support for the mmc clock phases using the framework This patch adds the 2 physical clocks for the mmc (drive and sample). They're mostly there for the phase properties, but they also show the true clock (by dividing by RK3288_MMC_CLKGEN_DIV). The drive and sample phases are generated by dividing an upstream parent clock by 2, this allows us to adjust the phase by 90 deg. There's also an option to have up to 255 delay elements (40-80 picoseconds long). This driver uses those elements (under the assumption that they're 60 ps long) to generate approximate 22.5 degrees options. 67.5 (22.5*3) might be as high as 90 deg if the delay elements are as big as 80 ps, so a finer division (smaller than 22.5) was not picked because the phase might not be monotonic anymore. Suggested-by: Heiko Stuebner <heiko@sntech.de> Signed-off-by: Alexandru M Stan <amstan@chromium.org> Signed-off-by: Heiko Stuebner <heiko@sntech.de> 2014-11-27 09:30:27 +08:00			`obj-y += clk-mmc-phase.o`
clk: rockchip: add a clock-type for muxes based in the grf Rockchip socs often have some tiny number of muxes not controlled from the core clock controller but through bits set in the general register files. Add a clock-type that can control these as well, so that we don't need to work around them being absent. Signed-off-by: Heiko Stuebner <heiko@sntech.de> 2016-12-27 07:00:38 +08:00			`obj-y += clk-muxgrf.o`
clk: rockchip: add new clock-type for the ddrclk Changing the rate of the DDR clock needs special care, as the DDR is of course in use and will react badly if the rate changes under it. Over time different approaches to handle that were used. Past SoCs like the rk3288 and before would store some code in SRAM while the rk3368 used a SCPI variant and let a coprocessor handle that. New rockchip platforms like the rk3399 have a dcf controller to do ddr frequency scaling, and support for this controller will be implemented in the arm-trusted-firmware. This new clock-type should over time handle all these methods for handling DDR rate changes, but right now it will concentrate on the SIP interface used to talk to ARM trusted firmware. The SIP interface counterpart was merged from pull-request #684 [0] into the upstream arm-trusted-firmware codebase. [0] https://github.com/ARM-software/arm-trusted-firmware/pull/684 Signed-off-by: Lin Huang <hl@rock-chips.com> Signed-off-by: Heiko Stuebner <heiko@sntech.de> 2016-08-22 11:36:17 +08:00			`obj-y += clk-ddr.o`
clk: rockchip: add reset controller All Rockchip SoCs at least down to the ARM9-based RK28xx include the reset- controller for SoC peripherals in their clock controller. While the older SoCs (ARM9 and Cortex-A8) use a regular scheme to change register values, the Cortex-A9 SoCs use a hiword-mask making locking unecessary. To be compatible with both schemes the reset controller takes a flag to decide which scheme to use, similar to the other HIWORD_MASK flags used in the clock framework. Signed-off-by: Heiko Stuebner <heiko@sntech.de> Acked-By: Max Schwarz <max.schwarz@online.de> Tested-By: Max Schwarz <max.schwarz@online.de> Signed-off-by: Mike Turquette <mturquette@linaro.org> 2014-07-03 07:59:39 +08:00			`obj-$(CONFIG_RESET_CONTROLLER) += softrst.o`
clk: rockchip: add clock driver for rk3188 and rk3066 clocks This adds a clock driver that handles the specific muxes, dividers and gates of rk3188 and rk3066 SoCs. The structure of the clock list resembles the arrangement of their counterparts in the clock architecture diagrams found in the SoC documentation. Clocks exported to the clock provider are currently limited to well known or measured ones. So additional clock exports may be necessary in the future. Signed-off-by: Heiko Stuebner <heiko@sntech.de> Acked-By: Max Schwarz <max.schwarz@online.de> Tested-By: Max Schwarz <max.schwarz@online.de> Signed-off-by: Mike Turquette <mturquette@linaro.org> 2014-07-03 08:01:14 +08:00
clk: rockchip: rename RK1108 to RV1108 Rockchip finally named the SOC as RV1108, so change it. Signed-off-by: Andy Yan <andy.yan@rock-chips.com> [include rename in rk1108.dtsi to prevent compile errors] Signed-off-by: Heiko Stuebner <heiko@sntech.de> 2017-03-18 01:18:38 +08:00			`obj-y += clk-rv1108.o`
clk: rockchip: add clock controller for rk3036 Add the clock tree definition for the new rk3036 SoC. Signed-off-by: Xing Zheng <zhengxing@rock-chips.com> Signed-off-by: Heiko Stuebner <heiko@sntech.de> 2015-11-05 15:33:58 +08:00			`obj-y += clk-rk3036.o`
clk: rockchip: add clock driver for rk3188 and rk3066 clocks This adds a clock driver that handles the specific muxes, dividers and gates of rk3188 and rk3066 SoCs. The structure of the clock list resembles the arrangement of their counterparts in the clock architecture diagrams found in the SoC documentation. Clocks exported to the clock provider are currently limited to well known or measured ones. So additional clock exports may be necessary in the future. Signed-off-by: Heiko Stuebner <heiko@sntech.de> Acked-By: Max Schwarz <max.schwarz@online.de> Tested-By: Max Schwarz <max.schwarz@online.de> Signed-off-by: Mike Turquette <mturquette@linaro.org> 2014-07-03 08:01:14 +08:00			`obj-y += clk-rk3188.o`
clk: rockchip: add clock controller for rk3228 Add the clock tree definition for the new rk3228 SoC. Signed-off-by: Jeffy Chen <jeffy.chen@rock-chips.com> Signed-off-by: Heiko Stuebner <heiko@sntech.de> 2015-12-11 09:30:50 +08:00			`obj-y += clk-rk3228.o`
clk: rockchip: add clock controller for rk3288 Add the clock tree definition for the new rk3288 SoC. Signed-off-by: Heiko Stuebner <heiko@sntech.de> Acked-By: Max Schwarz <max.schwarz@online.de> Tested-By: Max Schwarz <max.schwarz@online.de> Signed-off-by: Mike Turquette <mturquette@linaro.org> 2014-07-03 08:02:37 +08:00			`obj-y += clk-rk3288.o`
clk: rockchip: add clock controller for rk3328 Add the clock tree definition for the new rk3328 SoC. Signed-off-by: Elaine Zhang <zhangqing@rock-chips.com> Signed-off-by: Heiko Stuebner <heiko@sntech.de> 2016-12-29 10:45:11 +08:00			`obj-y += clk-rk3328.o`
clk: rockchip: add rk3368 clock controller Describe the clock tree and software resets of the rk3368 ARM64 SoC Signed-off-by: Heiko Stuebner <heiko@sntech.de> Signed-off-by: Stephen Boyd <sboyd@codeaurora.org> 2015-07-05 17:00:20 +08:00			`obj-y += clk-rk3368.o`
clk: rockchip: add clock controller for the RK3399 Add the clock tree definition for the new RK3399 SoC. Signed-off-by: Xing Zheng <zhengxing@rock-chips.com> Signed-off-by: Heiko Stuebner <heiko@sntech.de> 2016-03-28 17:51:37 +08:00			`obj-y += clk-rk3399.o`